Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 3 - Last Post: Nov 10, 2009 8:45 AM Last Post By: TommyQian-Autod... Threads: [ Previous | Next ]
Dan.M

Posts: 69
Registered: 01/19/09
Ipart table
Posted: Nov 6, 2009 4:34 PM
  Click to reply to this thread Reply
Attachment ipart table.JPG (186.0 KB)
Hello all ,



I have a small problem with the iparts table . If i attach a dimension that is defined as an equasition , I see in the table that equasition . What I want to see is the value of that dimension . Can it be done ?



Thanks ,



DAN
Senthil Kumar \...
Re: Ipart table
Posted: Nov 9, 2009 8:15 AM   in response to: Dan.M in response to: Dan.M
  Click to reply to this thread Reply


Hi Dan,

 

Could you please post this question in Inventor
Newsgroup so that you will get an from Inventor experts quickly?

 

Thanks

Senthil
Dan.M

Posts: 69
Registered: 01/19/09
Re: Ipart table
Posted: Nov 9, 2009 2:07 PM   in response to: Senthil Kumar \... in response to: Senthil Kumar \...
  Click to reply to this thread Reply
My mistake , i will repost in the right forum .

Thanks ,

Dan
TommyQian-Autod...

Posts: 46
Registered: 09/28/08
Re: Ipart table
Posted: Nov 10, 2009 8:45 AM   in response to: Dan.M in response to: Dan.M
  Click to reply to this thread Reply
Hi Dan,

There is no direct way to show the value. Here is the workaround.

First, in the Parameter, export the parameter you want to see in the iPart table. Then the parameter will be shown in iProperties dialog > Custom tab

Then, in the iPart table, in Properties tab > Custom group, select the exported iproperties. Now you will see the value.

Hope this helps.

Regards,
Tommy

Point your RSS reader here for a feed of the latest messages in all forums
Go Back Back to Thread List
Threads: [ Previous | Next ]