Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 4 - Last Post: Nov 7, 2009 6:51 PM Last Post By: Meikka Threads: [ Previous | Next ]
Meikka

Posts: 51
Registered: 08/11/09
Dimensioning
Posted: Nov 6, 2009 1:39 PM
  Click to reply to this thread Reply
Attachment 31856.dwg (624.6 KB)
Hello,

Have encountered problems with dimensioning. In the 31856.dwg the diameter measurement 36 takes on
a peculiar appearance. Perhaps there are some settings that I as a novice am unaware of.
Please advice. My version is INV2009.

Thank You again,
Martti
Meikka

Posts: 51
Registered: 08/11/09
Re: Dimensioning
Posted: Nov 6, 2009 1:42 PM   in response to: Meikka in response to: Meikka
  Click to reply to this thread Reply
Attachment 31856.ipt (497.5 KB)
31856.ipt
Dennis Jeffrey
Re: Dimensioning
Posted: Nov 6, 2009 1:49 PM   in response to: Meikka in response to: Meikka
  Click to reply to this thread Reply
Attachment a-000096.png (62.6 KB)
I had no problems in a later version of Inventor. See attached. Have you
installed all the service packs for Inventor 2009?
--
Dennis Jeffrey, Autodesk Inventor Certified Expert
Autodesk Manufacturing Implementation Certified Expert.
Instructor/Author/Sr. App Engr. Tel. (260) 399-6615
http://teknigroup.com
andrewiv

Posts: 519
Registered: 09/21/06
Re: Dimensioning
Posted: Nov 6, 2009 2:19 PM   in response to: Dennis Jeffrey in response to: Dennis Jeffrey
  Click to reply to this thread Reply
I had no problems using IV2009 SP2.
Meikka

Posts: 51
Registered: 08/11/09
Re: Dimensioning
Posted: Nov 7, 2009 6:51 PM   in response to: Dennis Jeffrey in response to: Dennis Jeffrey
  Click to reply to this thread Reply
Thanks Dennis,

SP worked, no problems at the moment.

/Martti :-)

Point your RSS reader here for a feed of the latest messages in all forums
Go Back Back to Thread List
Threads: [ Previous | Next ]