Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 1 - Last Post: Nov 3, 2009 10:03 PM Last Post By: mholman2 Threads: [ Previous | Next ]
mholman2

Posts: 28
Registered: 02/04/09
Section View of Design Accelerator Parts
Posted: Nov 3, 2009 9:55 PM
  Click to reply to this thread Reply
Hi,
I've created a shaft using design accelerator and now I am creating the drawing for it. I can't, however, figure out how to get an accurate section view of it.
When I create the section view, all i see is a side Projected View. The shaft essentially isn't sliced. Any input would be greatly appreciated.
-Matt
mholman2

Posts: 28
Registered: 02/04/09
Re: Section View of Design Accelerator Parts
Posted: Nov 3, 2009 10:03 PM   in response to: mholman2 in response to: mholman2
  Click to reply to this thread Reply
Never mind, I figured it out.

I didn't realize the shaft is created as an assembly. I had to back track to the actual part file and use that in the drawing.

Point your RSS reader here for a feed of the latest messages in all forums
Go Back Back to Thread List
Threads: [ Previous | Next ]