We have a DWF containing 400+ sheets that was created via the Sheet Set Manager in AutoCAD 2008. We have since upgraded to AutoCAD 2009 and now when we plot the DWF the sheets appear off center and zoomed in when viewed in Autodesk Design Review. Is there any setting that I can check in the properties of the Sheet Set Manager before plotting to correct this behavior?
Thanks
Dean Saadallah
Re: Plotting DWF Help
Posted:
Oct 26, 2009 12:56 PM
in response to: tsovich
You need to correct the settings in AutoCAD prior to creating the DWF files: is 2009 fully patched/updated? Post in the R2009 area for additional guidance.
"You need to correct the settings in AutoCAD prior to creating the DWF files"
....right, which was my original question. What settings can I check in the AutoCAD sheet set manager to correct this issue? The DWF ran fine under AutoCAD 2008.
"is 2009 fully patched/updated?"
Yes it is, here is the information: Product Name: AutoCAD Map 3D 2009 Product service pack: AutoCAD Map 3D 2009 Version 4 Product version: C.711.0 (UNICODE)
Thanks again for your help.
Dean Saadallah
Re: Plotting DWF Help
Posted:
Oct 26, 2009 7:19 PM
in response to: tsovich
Also, you issue is most likely a pagesetup that needs revised from 2008, not an SSM setting: SSM is simply a sheet handler, it does not print or publish or control either function.
