Discussion Groups

All Discussion Groups » Autodesk Design Review

Thread: PDF printing

Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 1 - Last Post: Oct 28, 2009 9:42 AM Last Post By: wube Threads: [ Previous | Next ]
stinger75

Posts: 2
Registered: 10/21/09
PDF printing
Posted: Oct 23, 2009 9:21 AM
  Click to reply to this thread Reply
We normally print in PDF for our costumers, so they can plot the drawing on their own printer with our sheet measurements.

But with ADR2010, when I click to use the PDF printer, my paper measurments turns from mm to inches. it discards our sheet measurements.

Is there a way to keep the measurements in mm and not having them change to inches when printing to PDF?.
wube

Posts: 10
Registered: 06/08/09
Re: PDF printing
Posted: Oct 28, 2009 9:42 AM   in response to: stinger75 in response to: stinger75
  Click to reply to this thread Reply
Thank you for your question.

Could you try the following steps:
1, Open your file
2, At “Markup & Measure” Tab click “Measure” button.
3, Select “2D Units & Scale”
4, Then a dialog pop up, select “Millimeters” in the “Display Units” Group.
5, Click ok and print your file again.

Please let me know if this suggestion is helpful or if you have any follow-on questions.

Ben

Point your RSS reader here for a feed of the latest messages in all forums
Go Back Back to Thread List
Threads: [ Previous | Next ]