Reply to this Thread Reply to this Thread Search Forum Search Forum Back to Thread List Back to Thread List

Permlink Replies: 2 - Last Post: Oct 29, 2009 2:10 PM Last Post By: bpiwinny Threads: [ Previous | Next ]
bpiwinny

Posts: 19
Registered: 07/03/08
update signal and wire numbers along many drawings
Posted: Oct 19, 2009 11:47 AM
  Click to reply to this thread Reply
Hi,

I have a signal that runs along many drawings (for example : from drawing 1 to drawing 15).
When I create source, then destination signal, there is no problem and my wires are named correctly.
If I modify manually my wire on the first drawing, the command for the update of the signal on all the project (AEUPDATESIGREF) update 2 or 3 drawing, but not all my 15 drawing.
Then, if I try again the same command, the 2 following drawings are updated !!!

Bad manipulation ? or bug ?

Could you try and say me ?

Best regards.
RealSoftwareSol...

Posts: 1
Registered: 10/29/09
Re: update signal and wire numbers along many drawings
Posted: Oct 29, 2009 11:21 AM   in response to: bpiwinny in response to: bpiwinny
  Click to reply to this thread Reply
It might be helpful if you can post your dataset and project to the discussion forum. Then I can test it to see if i see the same results or if I can see any type of error when it only does the first few pages.

thanks
Rob Stein
Real Software Solutions.
bpiwinny

Posts: 19
Registered: 07/03/08
Re: update signal and wire numbers along many drawings
Posted: Oct 29, 2009 2:10 PM   in response to: RealSoftwareSol... in response to: RealSoftwareSol...
  Click to reply to this thread Reply
Attachment signal test.zip (520.3 KB)
Here it is.

If you modify the wire number in the first drawing and the use the command AEUPDATESIGREF to update, you will see that your new number is copied on 2 or 3 drawings but not on the complete list.

bpiwinny

Point your RSS reader here for a feed of the latest messages in all forums
Go Back Back to Thread List
Threads: [ Previous | Next ]